Affiliate disclosure: As an Amazon Associate we earn from qualifying purchases. Links to Amazon in this post may earn us a commission at no extra cost to you. Learn more.
Large 3D printers are not just bigger, they are a different commitment. The Sovol SV08 Max has a 500 x 500 x 500 mm build volume and a headline speed of 700 mm/s. This overview uses Sovol’s own product and blog pages and Tom’s Hardware’s review of the original SV08. We have not tested the Max.
The specs from Sovol
Sovol lists a 500 x 500 x 500 mm build volume (500 x 500 x 450 mm with the enclosure kit), a CoreXY layout, an aluminium frame and linear rails on the X, Y and Z axes. Maximum speed is 700 mm/s, with 40,000 mm/s2 maximum acceleration and a 50 mm3/s maximum flow. The hotend reaches 300 degrees C and the 8 mm aluminium bed reaches 100 degrees C at 1,300 W.
It runs Klipper firmware, with OrcaSlicer supported and Cura and PrusaSlicer listed on a features page. It adds eddy-current bed leveling, a built-in 1280 x 720 camera, filament runout detection, power-loss resume and an auxiliary feeder with tangle and clog detection. Files are linked to Sovol’s GitHub page.
About the Voron connection
Tom’s Hardware says the original SV08 is styled after the Voron 2.4, an open-source design. That is the SV08, not the Max, and we could not confirm the Max’s lineage, so we are not claiming it.
Drawbacks
Sovol’s own review post admits some users report tool-head board connection loss, Error 8 print stops and less detail on curves at top speed. 700 mm/s is a maximum, not a typical print speed. Tom’s Hardware’s cons for the original SV08 included a basic touchscreen and conservative default profiles.
Who it suits
Makers who need large parts and are comfortable tuning Klipper. If you are just starting, our beginner 3D printer guide is a gentler place to begin.
Where to find it
Search for the Sovol SV08 Max on Amazon, and check whether the listing includes the enclosure variant.
Bottom Line
The SV08 Max is a big, fast, feature-rich open-source printer on paper. Expect to tune it, and treat the speed numbers as best case.
FAQ
How big is the build volume?
500 x 500 x 500 mm, or 500 x 500 x 450 mm with the enclosure kit.
Does it run Klipper?
Yes, Sovol lists Klipper firmware with OrcaSlicer support.
Is 700 mm/s realistic?
It is a maximum. Sovol’s own post notes less curve detail at top speed.
Featured image: Photo by Quilia on Unsplash (a generic 3D printer, not the SV08 Max). Video: Sovol, official YouTube channel.
No comments yet. Be the first to share your thoughts below.